made in china famous motor factory wound rotor high voltage ac motor
made in china famous motor factory wound rotor high voltage ac motor Ploes : 2,4 , 6, 8, 10 ,12 ,16poles Frequency (Hz) : 50 or 60HZ Insulation : F Duty : SI Protection : IP 55/54/44 Ambient Temp : -15- 45°C Rating : 200-15000 kW Rating & Performance : IEC : 34-7,GB/T997 Cooling type: IC01,IC611,IC81W Protection Class: IP23,IP44,IP54 Mounting type: IMB3(or as requested)
Send Inquiry NowDownload Instruction
Our Product Detail
This is the description of made in china famous motor factory wound rotor high voltage ac motor




Standard Features
- Sinusoidal power supply of 3000v to 11,000 V
- Motors manufactured in 2 to 16 poles
- welded steel plates for frame 355 to 1000
- Cooling methods used:
- Open self-ventilated;
- Self-ventilated by ducts, air inlet and outlet;
- Forced ventilated, air inlet and outlet by ducts;
- Forced ventilation, cooling on top of motor;
- air-to-air Cooler ;- Air-to-water Cooler ;other cooling methods can be design
- Mounting: B3
- Degree of Protection: IP23 to IP55
- Service duty: (S1)
- Class of insulation: F
- Service Factor: 1.0
- Ambient temperature: 40 °C
- Altitude: 1000 m
- Temperature detector: Pt100
- Single phase space heater
- Bearings: Rolling bearing or Sleeve bearings
- Electrically insulated non-drive end bearing for frames 450 and above, when connected directly to the power supply
- Stainless steel nameplate
- Grounding lug on the frame and terminal box
- Grounding brush on drive end shaft for frame size 450 and above
- Stainless steel slip rings
- Service Factor: 1.15
- Class of insulation: H
- Temperature rise: 105°K for class F
- Temperature rise: 125°K for class H
- Ambient temperature above 40 °C (on request)
- Altitude above 1000 m (on request)
- Mountings: B5, B35, V1, V3, V5, V6, V18, V19, V36
- Degree of Protection IPW55 and above
- Classified area application: Ex-n, Ex-e, Ex-p
- Special balance
- Base: rail, sliding base, extended feet, rebuilt feet, anchorage plate
- Steel welded terminal box in different sizes, based on internal available space
- Power factor correction capacitors
- Non-reversion ratchet
- Centrifugal switch
- Temperature detector: Thermistor (PTC or NTC)
- Temperature detector: Thermostat (Bimetallic)
- Two energized power terminal boxes
- One or more accessory terminal boxes
- Shaft: Special dimensions, double shaft end, tapered, hollow, special steel
- Sleeve bearing
- Oil lubricated bearing
- Special bearing (overdesigned) for axial or radial thrust
- Special painting
- Terminal block for low voltage
- Cable gland in the terminal box entrance
- Protection against voltage surge: Lighting arrestors and Capacitors
- Aluminum, copper or brass rotor
- Vibration detector
- Noise suppressor in the air inlet and outlet
- Encoder
- Tachogenerator